Scheduled Downtime
On Tuesday 24 October 2023 @ 5pm MT the forums will be in read only mode in preparation for the downtime. On Wednesday 25 October 2023 @ 5am MT, this website will be down for maintenance and expected to return online later in the morning.
Normal Operations
The forums are back online with normal operations. If you notice any issues or errors related to the forums, please reach out to help@ucar.edu

Change STOP_N during running but does not work

J

Jack_ecology

Jack
New Member
Dear,

I am running a B1850 case 'start up' using CESM2.1.0. Before running, I set STOP_OPTION=nyears, STOP_N=5, and then started to run. When it is running, I changed STOP_N to 4 but now the model is still running after 4 years. I remember env_run.xml can be changed during the running, is it correct? Now my TIME_LIMIT does not allow me to run the total of 5 years. Are there some ways to stop running? I aim for 100 years running.
 
erik

erik

Erik Kluzek
CSEG and Liaisons
Staff member
Technically you can change the STOP options while the model is actually running -- but the change will NOT take effect until after it's run the current cycle. It will take effect the next time the model restarts. To stop the model running midstream, you can kill the job with the normal batch commands to do that for your system. But, if you just want to run for a 100 years, you might as well wait until the current cycle is done.
 
You must log in or register to reply here.
Top