Scheduled Downtime
On Tuesday 24 October 2023 @ 5pm MT the forums will be in read only mode in preparation for the downtime. On Wednesday 25 October 2023 @ 5am MT, this website will be down for maintenance and expected to return online later in the morning.
Normal Operations
The forums are back online with normal operations. If you notice any issues or errors related to the forums, please reach out to help@ucar.edu

Error in esmf when making CLM ground data mapping

Status
Not open for further replies.
W

weixinyu

weixinyu
Member
Hi all
To make a mapping of CLM surface data, run in the mkmapdata directory. /mkmapdata.sh -r $GRIDNAME -f $GRIDFILE -t regional
When I run the mkmapdata directory, it shows the error as shown in the picture, according to the error display, I go to the corresponding location and see that it is an error in the esmf environment variable, may I ask what should be set according to here?
I will list the error message (Figure 1) and my own ESMF environment settings (Figure 2), please help answer!
Thank you very much!


1.png2.png
 
O

oleson

Keith Oleson
CSEG and Liaisons
Staff member
I'm not sure but I think this means that your version of ESMF was not built with netcdf support. Also, version 7.0.2 may be a bit old. The last I ran this on our machine we were using 8.0.0.
 
W

weixinyu

weixinyu
Member
oleson said:
I'm not sure but I think this means that your version of ESMF was not built with netcdf support. Also, version 7.0.2 may be a bit old. The last I ran this on our machine we were using 8.0.0.
Click to expand...
Thank you very much for your reply!
I reinstalled the new version of ESMF, so far it shows that the installation is successful, but when making map files, it only makes one map file successfully, and fails to the second one, I put the error message in the screenshot, please help me to look at it, thank you very much!

1717061724413.png

1717061744689.png
 
Status
Not open for further replies.
Top