user_defiend

  1. T

    "Lagrangian levels are crossing" and "SIGSEGV, segmentation fault" error on custom grid

    Dear All, I'm trying to run an aquaplanet (QPC6, a compset I have used extensively with f19 resolution) simulation on a custom grid using CESM 2.1.3, but the case fails on execution. I have setup a custom 2x20 grid ( actually ~1.9x20 with nlat 96 and nlon 18 ) following 3.2 of these...
  2. T

    Problem in initializing cesm2 with a new grid

    Dear All, I'm trying to run an aquaplanet (QPC6, a compset I have used extensively with f19 resolution) simulation on a custom grid using CESM 2.1.3, but the case fails on execution. I have setup the custom 2x20 grid following 3.2 of these instructions and with guidance on this thread. I am...
  3. T

    Adding a new grid for cesm2

    I have been using CESM 2.1.1 in the aquaplanet setting for certain idealized studies. In this regard, I would like to perform certain experiments with a very coarse resolution in the longitudinal direction, say, for example, maybe a dlon of 15 ~ 20 degrees. In this regard, I have been following...
  4. T

    Adding a new grid for cesm2

    Hello everyone, I have been using CESM 2.1.1 in the aquaplanet setting for certain idealized studies. I want to perform certain experiments in the aquaplanet setting with a very coarse resolution in the longitudinal direction, for example, maybe a dlon of ~15 - 20 degrees. In this regard, I have...
  5. W

    error in producing namelist

    Hello, I am new to the CESM, I am following the user Manuel to produce Macro file and then configure "Build configuration for a 'user defined' machine". I was able to follow all the steps in env_build.xml, env_mach_pes.xml, and run_.xml. after that, I executed ./cesm_setup from the test folder...
Back
Top