'fv' model run error.

[ksk14307@snu_ac_kr]

Hello,
I have some problem running CAM3.1.p2 with the 'fv' dynamic core.
I made two kinds of initial data set (one is 4x5_fv_initial dataset, the other is 1x1.25_fv_initial dataset) using interpolation tools included CAM source. Data set used for interpolation are T85 datasets.

Model run was O.K. in case of '4x5_fv', but in '1x1.25' case the error was occured.

Error message is following.

==================================
aerosol_init: using namelist value for carscl, or default
aerosol_init: Using sulfate from cyclic climatology
p15_26478: p4_error: interrupt SIGSEGV: 11
rm_l_15_26479: (32.976562) net_send: could not write to fd=5, errno = 32
Lagrangian time splits (NSPLIT) = 4
aerosol_init: using namelist value for carscl, or default
aerosol_init: Using sulfate from cyclic climatology
Lagrangian time splits (NSPLIT) = 4
aerosol_init: using namelist value for carscl, or default
aerosol_init: Using sulfate from cyclic climatology
Lagrangian time splits (NSPLIT) = 4
aerosol_init: using namelist value for carscl, or default
aerosol_init: Using sulfate from cyclic climatology
...............
...............
...............
==================================

Also when I used initial datasets provided by NCAR(4x5_fv and 2x2.5_fv), only 4x5_fv run was O.K.
The error message was same.

Changes in configure step were ;
configure -spmd -dyn fv -res 4x5 for 4x5_ fv_run
configure -spmd -dyn fv -res 2x2.5 for 2x2.5_fv_run



Could anybody give me some comments about solving this problem ?



Thanks in advance.
Sang Ki.