m_mineter@ed_ac_uk
Member
I am installing cesm2.1.3-rc.01-0-g0596a97
The xml config files refer to mpi-serial and to cprnc
I think I need to build these
1. is there any other utility/library in the installation that I should also build before I can meaningfully run tests, please?
2. mpi-serial
I see the code in my_cesm_sandbox/cime/src/externals/mct/mpi-serial
I use an intel 2017 compiler, and note the README says 4 bytes is the default, so is the following likely to be correct?
CC-icc FC=ifort ./configure --enable-fort-real=8 --enable-fort-double=16
(Do you happen to know if any other flags are desirable for Intel compilation here?)
make
make tests
3. cprnc
Can this run with the parallel netcdf library I had built, or do I need a sequential one for this?
(the README refers to mpi-serial - hence I assume I need to build mpi-serial first.)
Thanks
The xml config files refer to mpi-serial and to cprnc
I think I need to build these
1. is there any other utility/library in the installation that I should also build before I can meaningfully run tests, please?
2. mpi-serial
I see the code in my_cesm_sandbox/cime/src/externals/mct/mpi-serial
I use an intel 2017 compiler, and note the README says 4 bytes is the default, so is the following likely to be correct?
CC-icc FC=ifort ./configure --enable-fort-real=8 --enable-fort-double=16
(Do you happen to know if any other flags are desirable for Intel compilation here?)
make
make tests
3. cprnc
Can this run with the parallel netcdf library I had built, or do I need a sequential one for this?
(the README refers to mpi-serial - hence I assume I need to build mpi-serial first.)
Thanks