Running at 0.47x0.63 - Restart Files

[ah828]

I am trying to run the I2000Clm50BgcCrop compset w/ SROF at f05_f05_mg17 resolution from 2011 using the restart files located at /glade/p/cisl/dares/RDA_strawman/CESM_ensembles/CLM/CLM5BGC-Crop/ctsm_2011-01-01-00000.

However, this data appears to be at a coarser resolution and so is imputed prior to my case being run which is resulting in some artifacts (below plot is ELAI)



Does anyone know if there are restart files for the CLM5BGC-Crop compset at f05_f05_mg17 resolution on Cheyenne or anywhere else or will I have to run my own spin-up?

Are there any other methods to address this issue?

Thank you!

 

[slevis]

Hi @ah828,
Look here for other restart files, in case you find something useful:
/glade/p/cesmdata/cseg/inputdata/lnd/clm2/initdata_map

 

[ah828]

Hi @ah828,
Look here for other restart files, in case you find something useful:
/glade/p/cesmdata/cseg/inputdata/lnd/clm2/initdata_map

Thanks Sam! I didn't see anything at half a degree in there, so I'm assuming I will need to run my own spin-up following these directions?

 

[slevis]

I had hoped that one of the 360x720cru files might have worked for you. If not, then, yes, you should run your own spin-up, and I'm pretty sure that you are looking at the correct section of the user's guide.