I used CMIP6 data to create an atmospheric forcing myself, but there were some issues after running it
Some questiones about Replace Atmospheric Forcing on CLM5.0
- Thread starter Jinglong Huang
- Start date
- Status
The atmospheric forcing I used before was CMFD, and the time and spatial resolution of the atmospheric forcing I made myself are the same as CMFD. After replacing it, I found that the above errors occurred, and I am not sure what the problem is
I'm afraid the error message does not provide enough information to understand what may be happening.
Am I understanding correctly that the model works fine with the CMFD atm. forcing but fails with the custom atm. forcing? In that case you will have to continue troubleshooting until you resolve the problem. For example, since the time and spatial resolutions are the same, you could go back to the version that works and start replacing atm. forcing files one at a time, instead of replacing them all at once.
Am I understanding correctly that the model works fine with the CMFD atm. forcing but fails with the custom atm. forcing? In that case you will have to continue troubleshooting until you resolve the problem. For example, since the time and spatial resolutions are the same, you could go back to the version that works and start replacing atm. forcing files one at a time, instead of replacing them all at once.
thank you
i will try
What I want to know is how it can be used to analyze data, such as CMIP6 data, to make predictions。
Where are the tutorials?
Where are the tutorials?
You should be able to access past tutorials through this page:
www.cesm.ucar.edu
For example, the latest CESM tutorial material is here:
Home | Community Earth System Model
www.cesm.ucar.edu
For example, the latest CESM tutorial material is here:
- Status